Home > Xbox 360 > Xbox 360 Eject Not Working

Xbox 360 Eject Not Working

Contents

it appears that the button itself was damaged, I didn't realize it because it was my first x-box tear-down. Transcript The interactive transcript could not be loaded. Denny Ross - April 1 Reply Add a comment Add Comment 1024 Step 23 Edit While pushing the upper and lower cases apart, use the tip of a spudger or the Sign in to add this video to a playlist. have a peek at this web-site

Category People & Blogs Licence Standard YouTube Licence Show more Show less Loading... Grasp the back portion of the lower case and lift it upwards to separate it from the console. Sign in Share More Report Need to report the video? You will insert the tool into the holes molded into the white plastic side case pieces.

My Xbox 360 Tray Won't Open

then take it out and slowly bend it. Just slide it in against the side of the case and the clip will pop off. If you wish to be unblocked, you must agree that you will take immediate steps to rectify this issue. PDattaTV 320,778 views 2:43 Part 3/4: How to Fix an Xbox 360 Disc Drive That Won't Open: Fixing or Replacing Rubber Band - Duration: 9:23.

Add a comment Add a comment Add Comment 1024 Step 9 Edit Repeat the same motions as previously mentioned to release the left side of the faceplate. Note If a disc is in the tray, make sure that it is not sticky and does not have a label that might prevent the tray from opening again in the Original Xbox 360 console: How to manually eject the disc tray Remove the faceplate First you need to remove your console’s faceplate. Xbox 360 Tray Won't Close Sign in Share More Report Need to report the video?

You can change this preference below. So I applied heat to the nub to make the plastic soft enough to push a sewing needle in it... Working... Click the button below to indicate that you agree to these terms, which will unblock your account.

Also on GameFAQs...Help - Answers to the most commonly asked questions about GameFAQs.FAQ Bookmarks - Access and manage the bookmarks you have added to different guides.FAQ Bounty - Write a FAQ Xbox 360 Manual Eject The disc tray should pop out slightly. GameFAQs Answers Boards Community Contribute Games What’s New Blocked IP Address Your IP address has been temporarily blocked due to a large number of HTTP requests. Follow these steps to manually eject the disc tray: Disconnect the power cord and any other cables connected to the console.

Xbox 360 Disc Tray Stuck

Note: It's more of a "semi" hole and there is one directly to the right of it. 4 Using a flashlight, place the end of the paper clip in the teeth Cancel The All-New Pro Tech Toolkit The high performance electronics repair kit. My Xbox 360 Tray Won't Open View the answer I have this problem too Subscribed to new answers Is this a good question? Original Xbox Tray Won't Open Their locations are highlighted in red.

We won't give up and neither should you. Check This Out Uncoil a large paper clip. Loading... Rating is available when the video has been rented. Xbox 360 Eject Button

Alternatively, you can use your hands to carefully pull the faceplate away from the Xbox. If your console does not have the hole pictured below, skip to step 5. I recommend watching this video from ScrewAttack, they'll show you how to do it.Awesome thanks, I thought it was gonna be a lot worse than that. Source The clip should release, leaving the clips near the power connector as the only thing holding the upper and lower cases together.

THIS ISSUE SEPARATE ISSUE Share this page Xbox Feedback Support Photosensitive Seizure Warning Code of Conduct Fans Xbox Wire For Developers Games [email protected] Windows 10 Jobs Designed for Xbox English (United How To Eject Disc From Xbox 360 With Controller Above the Memory Unit slots. You must use a large paper clip because it must be inserted about 1.5 inches (nearly 4 centimeters) to successfully eject the disc.

I am not sure if something broke/fell off the silver eject button or fell/broke off the CD/DVD ROM button but either way it has been working so far....

Sign up for free! Push the paper clip until you feel some resistance (about 1 inch or 2.5 cm into the hole). SexyToadFollowForum Posts: 2939Wiki Points: 3297Followed by: 0Reviews: 0 Lists: 0#7 Posted by SexyToad (2939 posts) - 4 years, 9 months agoI had that problem. Xbox 360 Disc Tray Stuck Open Microsoft has married the drives to the motherboard.

Plug the power cord into the back of the console. Autoplay When autoplay is enabled, a suggested video will automatically play next. Iseekoutthetruth 461,620 views 12:21 XBOX and XBOX 360 Stuck Drive Fix - Duration: 9:54. http://tekspotting.com/xbox-360/xbox-360-elite-eject-button-not-working.html Loading...

Learn more You're viewing YouTube in English (United Kingdom). Nick Karnik - 07/19/2014 Reply The small (metal) women's hair clip is best for un-latching the tabs. While slightly lifting the front edge of the bottom vent, use the tip of a spudger to push the clips closest to the front of the bottom vent towards the inside Position the console horizontally, as you would position a DVD player.